open from 8 a.m. to 5 p.m

+380 (67) 232-95-11 (Telegram, Viber) +380 (61) 220-26-96

moc.dnargllor%40reganam

ROLL GRAND

All for the motion of metal constructions

open from 8 a.m. to 5 p.m

+380 (67) 232-95-11 (Telegram, Viber) +380 (61) 220-26-96

moc.dnargllor%40reganam

ROLL GRAND

All for the motion of metal constructions

Console kit #1

* The complete set can change at the request of the customer.

  • Illustration

    Large guide - 1 m.p.

    Art.
    1100

    Purpose: for the manufacture of cantilever gates weighing up to 800 kg and a passage width of up to 10 m. It is used to move the gate in a given direction through the carrier carriages.

    Installation: by special welding to the lower part of the cantilever gate frame.

    Material: ordinary quality carbon steel.

  • Illustration

    Carrying carriage

    Art
    1240

    Purpose: provides movement of cantilever gates weighing up to 800 kg in a given direction.

    Installation: the base of the carrier carriage is fixed by welding to the embedded element or installed on the adjusting support with the help of fastening elements. The roller system of the carrier carriage is installed inside the large guide.

    Material: carbon steel with galvanic coating.

  • Illustration

    Limiter

    Art
    1310

    Purpose: to direct the canvas of cantilever gates weighing up to 800 kg, to eliminate distortions and vibrations during operation.

    Installation: by welding to the supporting structure (column, wall with prepared metal elements, etc.).

    Material: carbon steel with galvanic coating, polymer.

  • Illustration

    Catcher

    Art
    1410

    Purpose: holds the load from the End roller in the closed position of the cantilever gate weighing up to 800 kg; uses, as an additional support, the reducing forces acting on the Carriage carriers.

    Installation: by means of welding or fastening elements to the supporting structure (column, wall with prepared metal elements, etc.).

    Material: carbon steel with galvanic coating.

  • Illustration

    Support wheel nylon

    Art
    1510

    Purpose: reduces the load on the carriages in the closed position of the cantilever gate weighing up to 800 kg.

    Installation: with the help of fasteners to the Large Guide. When adjusting the position of the gate leaf, the end roller must completely enter the Catcher, and the gate leaf must rise by 5-100 mm - this is a mandatory condition.

    Material: carbon steel with galvanic coating; polymer.

  • Illustration

    Nylon caps big

    Art
    1610

    Purpose: to protect against the ingress of water, dirt, snow, leaves, etc. into the Large Guide, as well as as a damper at the moment of closing the cantilever gate weighing up to 800 kg.

    Installation: fixed from both ends of the large guide.

    Material: polymer.